RE: IML: colling system pressure?

[therichardsonfamily@xxxxxxxxxxx]

Thank you very much for the info on the filter.  That sounds like a smart way to go.

Tonight, I played it safe (I think I'm glad I did) and pulled the thermostat.  By regulating the amount of water flow, I was able to acheive what was probably 130 degrees coming out the upper hose.  While that's not quite operating temp., it allowed things to probably dislodge a bit more.  I also put full pressure on and ran the engine at a higher speed.  That's what got rusty water to come out.

Next step will be an old radiator & "Cascade", and a backflush on the heater core (has been bypassed thus far).  Then a filter and the new radiator.

Thanks everyone for the help.  By the way Dave, my feet are soaked!

Dan Richardson
300L Family Heirloom


 -------------- Original message ----------------------
From: Ken Lang <imperialken@xxxxxxxxx>
> Ya know, I forgot to add, that if you do install an in-line filter, it might
> be a good idea to drive it around a bit without the thermostat to get
> maximum flow.  Then after you've thoroughly dislodged everything and trapped
> it in the filter you can re-install the stat.
> 
> Ken
> 
> 
> 
> -----Original Message-----
> From: mailing-list-owner@xxxxxxxxxxxxxxxx
> [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of
> therichardsonfamily@xxxxxxxxxxx
> Sent: Tuesday, February 20, 2007 6:55 PM
> To: mailing-list@xxxxxxxxxxxxxxxx
> Subject: Re: IML: colling system pressure?
> 
> OK, thanks for everyone's input on the water jacket pressure question.
> 
> I think Dave's experience with head gasket failure with water pressure at
> 30-40 psi will make me pull the thermostat and run the water through with
> the system "open".  Following a good flushing, I will probably throw in an
> old radiator and do the "Cascade" cleaning.
> 
> I do like the filter idea.  Ken, will you share your info with the list
> regarding a source?
> 
> Thanks again everyone for your help.  I'll be back with more questions.
> 
> Dan Richardson
> 300L Family Heirloom


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm