Re: IML: Fuel Tank - checking the sending unit

["Lupe Rodriguez" <lupee@xxxxxxx>]

The dash fuel gauge worked at first and then it would only 
show half full and then barley registered anything with a 
full tank. After removing the fuel tank I discovered the 
float full of fuel.  I did ground the sender when I checked 
it with an ohm meter.
Lupe
----- Original Message ----- 
From: "Michael O. Mann" <mann340s@xxxxxxxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Wednesday, January 17, 2007 7:13 PM
Subject: RE: IML: Fuel Tank - checking the sending unit


Lupe,

I don't know about repair, but it may help someone give you 
better
information if we know how your gauge was acting.  Did it 
show full or near
full all the time, as I'd expect with that resistance, or 
did it show very
high or low, or act erratically?  Maybe somebody with more 
knowledge can
interpret some symptoms.

Good luck.

Michael





-----------------  
http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. 
Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response 
will be
shared with everyone. Private messages (and attachments) for 
the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to 
http://imperialclub.com/unsubscribe.htm





-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm