RE: IML: Fuel Tank - checking the sending unit

["Michael O. Mann" <mann340s@xxxxxxxxxxxxx>]

Lupe,

I'm more familiar with the mid-60's A-bodies, but on several I've tested,
the readings are similar.  Use an ohmmeter to test resistance between the
connection on the outside of the unit, and ground.  If it's like the
A=bodies, you should see between seven and 70 ohms resistance.  At the
lowest point, as with the tank nearly empty, resistance should be highest,
around 70 ohms.  If you raise the float to mimic a full tank, resistance
should drop to around seven ohms.

Good luck.

Michael





-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm