Re: IML: In-door lubrication

["Klebert L. Hall" <swampyankee@xxxxxxx>]

> From: "Dan" <sunup@xxxxxxxxxxxxx>
> Subject: Re: IML: Please Welcome Andrew Richards
>
> A friend told me that spraying WD-40 on the window regulators of his '60
> made his windows work fine again. I believe they are riveted joints that 
> can
> become rusted and stick, especially after prolonged periods of non-use. I
> didn't ask if he did it from the top with an extension tip on the can or 
> if
> he had to remove the door panels. Maybe someone who has done it can help
> further...

  If people are looking for a spray lubricant, I reccommend going to a good 
hardware store (probably not The Despot, for example) and looking for spray 
chain-drive lubricant. It's designed for commercial rolling door drives, and 
the like. It's basically a spray grease, so it's nice and thick and clingy, 
and is designed to leave a persistant film of grease. I've had really good 
luck using it on the internal door-latch parts on my car, just spraying it 
through the little lubrication holes in the door. The rear doors haven't 
been used much over the years, and the latches were really stiff. It worked 
great on the hinges, too.
  To get the regulators, you'd probably have to take off the door panel.
       -Kle.
       '69 Crown 4DHT 




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm