Re: IML: Job number "next" - hub

["jsadowski" <jsadowski@xxxxxxx>]

Jerry,

One reason for not using a lot of heat when trying to separate the hub is that you want to heat the hub only. If the heat transfers to the axle, your fighting a losing battle. Another is that too much heat can cause warping or brittleness. I recall meeting someone at a show with a 66 convertible. He had used the heat method & the axle shattered on the highway. The left rear wheel came off the car at speed & did a fair amount of damage to the car. Fortunately, nobody was hurt.

John

----- Original Message -----

From: Jerry hesch

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Thursday, October 14, 2004 8:27 PM

Subject: Re: IML: Job number "next" - hub

...I'm not sure if these need a puller or not. I would definitely NOT use a torch to heat the hub. If you want to apply any heat, use a heat gun or even a hair dryer on high . Then try to remove.

John

 

 

John,

For the benefit of myself and the group, why would you not use a torch-the obvious concern of fire that could be minimized or concern re heat distribution causing warping?  I know there is a good reason and am one of those who does best when he knows "Why". 

Thank you

jerry hesch