|
I second the previous posts, but would add that the P/B assembly
should NOT be greased! The operating parts mostly
slide back and forth, and grease will attract and hold dirt, grit
and grime and lead to more problems. A good thorough cleaning with
solvents and air pressure, and some silicone spray lube that dries
completely, or perhaps some powdered graphite work just fine on the
button assembly. BC On 9/23/2014 11:19 AM, Richard Kinsley
wrote:
-- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/d/optout. |
Back to the Home of the Forward Look Network