Re: ball and trunnion conversion

["Dennis C." <dennis.2914@xxxxxxxxx>]

Neal,

Any driveshaft shop can make the coversion with off the shelf parts, I
have had two done.  I'm sure others can give more information.  As far
as the Ball and trunnion joint if it  is in good condition I would
service it and install a new boot.  If I had known boots and parts
were available I would not have coverted mine.

Dennis C.

On Oct 26, 6:58 am, neal zimmerman <neal.zimmer...@xxxxxxxxx> wrote:
>   These guys have a conversion unit to change ball and trunnion
> drive-lines to slip-yokes. never bought one so i cant personally
> vouch for it. a buddy used one in his 65 valiant and liked it. the
> website is kind of lame, no pictures, best to just call.http://www.sixstates.com/products/about.jsp
>    Neal Zimmerman, Eugene Oregon

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.