Yes, I bought a spray can with a small strawlike tube like the one that
comes with WD40.
Is that the best way to do it?
thanks
David
In a message dated 4/1/2011 10:54:59 P.M. Eastern Daylight Time,
micher@xxxxxxxxxxxxxxx writes:
How did you apply the lithium grease? Did you use the spray on
grease?....................MO
{Steve Mick}
http://stevemick1964dodge.shutterfly.com/pictures/5
----- Original Message -----
From: <Blosserde@xxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Friday, April 01, 2011 5:42 PM
Subject: Re: rear door panels 1964 Dodge Polara Hdtp
Thanks MO,
you beat me to the question. I will buy some next week. The doors still
had
the original plastic sheet in place with a rope caulk like you all told
me. I put white Lithium grease on all moving parts and the windows work
just
like from the factory.Now that I have the interior panels off, I will
take
it to a couple paint shops.
Also, there were a few wire clips that did pull out of the fiberboard. I
am
looking at some way to glue or reset if possible.
thanks for everyone's help.
David
In a message dated 4/1/2011 2:53:26 P.M. Eastern Daylight Time,
micher@xxxxxxxxxxxxxxx writes:
For all your panels, front and back. Get the heaviest Mil plastic
sheeting
you can find and cut it to fit your door and rear panel. . Attach it to
the
metal of the doors with a non hardening strip caulk befor installing
your
door panels. That creates a water barrier in back of your fiber panels
.......................MO
--
[Non-text portions of this message have been removed]
----
Please address private mail -- mail of interest to only one person --
directly to that person. I.e., send parts/car transactions and
negotiations as well as other personal messages only to the intended
recipient, not to the Clubhouse public address. This practice will
protect
your privacy, reduce the total volume of mail and fine tune the content
signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
----
Please address private mail -- mail of interest to only one person --
directly to that person. I.e., send parts/car transactions and
negotiations as
well as other personal messages only to the intended recipient, not to
the
Clubhouse public address. This practice will protect your privacy, reduce
the total volume of mail and fine tune the content signal to Mopar topic.
Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
[Non-text portions of this message have been removed]
----
Please address private mail -- mail of interest to only one person --
directly to that person. I.e., send parts/car transactions and
negotiations as well as other personal messages only to the intended
recipient, not to the Clubhouse public address. This practice will protect
your privacy, reduce the total volume of mail and fine tune the content
signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
Back to the Home of the Forward Look Network