Re: Upper control arm bolts

[Jim Rowland <dodge440@xxxxxxx>]

Bill;

I am taking my 65 in Monday, 9:30 AM  to have the front end aligned  
too. I hope I put the arms back as needed. A picture would sure help.  
After Small Group tonight i will be back under the 65 cornet checking  
the ride height to make sure it is + or - 1/8 '' per the manual. I  
will recheck the control arms also.

Jim

65 Cornet 500.


On May 1, 2010, at 6:57 PM, William Harrison wrote:


Help
I can't remember which way the bolts face when they go back into the  
upper control arms.
I am taking my 65 in Monday to have the front end aligned and the guy  
said to make sure the bolts were in right or they wouldn't do the  
alignment.
Any help appreciated.
Thanks
Bill


----
Please address private mail -- mail of interest to only one person --  
directly to that person.  I.e., send parts/car transactions and  
negotiations as well as other personal messages only to the intended  
recipient, not to the Clubhouse public address. This practice will  
protect your privacy, reduce the total volume of mail and fine tune  
the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html 
.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.