Re: Pinion snubber

[Roger Pettigrew <dodger7998@xxxxxxx>]

depending on the weakness of the springs,,,,,,,,,,,should not touch except  
on acceleration,,,,,,,,,,it is not used to adjust the pinion angle, it is used  
to eliminate spring wind-up
 
 
In a message dated 6/5/2008 9:54:05 P.M. Central Daylight Time,  
spigot2039@xxxxxxxxxxx writes:


Wasn't it between four and eight degrees of positive pinion  angle?

Gary H.

-----Original Message-----

>Rich  Kinsley '64 Dodge Polara 4dr 318poly w/goodies
>
>I remember once  someone mentioning the proper postion for a pinion 
>snubber. About how  far from the floorboard should it be? Mine was about 
>1" plus so I put  it one notch up and just noticed that it actually 
>touches the floor  board. Whoops. No wonder it started riding so hard :-) 
>What should it  be? 


----
Please address private mail -- mail of interest to  only one person -- 
directly to that person.  I.e., send parts/car  transactions and negotiations as 
well as other personal messages only to the  intended recipient, not to the 
Clubhouse public address. This practice will  protect your privacy, reduce the 
total volume of mail and fine tune the  content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse  Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.  






**************Get trade secrets for amazing burgers. Watch "Cooking with 
Tyler Florence" on AOL Food.      
(http://food.aol.com/tyler-florence?video=4?&NCID=aolfod00030000000002)

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.