Neat solution

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

I was looking at the carbs and discovered an easy and permanent mod to 
those dubious internal secondary butterflies. I had drilled the weights 
per Eddy and as Jeff, I think, mentioned I was looking on how to 
temporarily block them open. Well the drilled holes are sticking 
straight up and right against the side of the carb body. So I figure 
I'll just tap the hole and run a screw in there  to hold them open when 
and if I want to run it with the butterflies open. Otherwise just remove 
the screws. Cool :-)


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.