RE: temp lever direction

[Dan McCormack <mcwheels@xxxxxxxxxxxxxx>]

Sean when you pull it down for more heat it pushes the cable out to open 
the valve. Below is a link to the valve I used. You need the 
BPE3116(reversed)

Dan 

http://www.bouchillonperformance.com/BPEheaterValve.asp


Sean B wrote:
> 
> 1964 Plymouth.  The temp lever for the heater, which says "WARM" on the 
> knob.  When I pull it down for more heat, does it push the cable out on 
> the opposite end, or does it pull it in?
> 
> I'm trying to buy an aftermarket valve to replace the worn out factory 
> valve.
> 
> Thanks!
> 
> Sean


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.