RE: Wanted:64 4 spd. tail housing

[Dave Walters <whdavid@xxxxxxxxx>]

Dodger7998@xxxxxxx wrote:
> 
> 
> Is the tail housing compatiable with the latter model output  shaft with 
> it 
> being a flange type housing on the 64?
>                                                                              
> dodger
> 
> [Non-text portions of this message have been removed]
> 

No,but I think I know where one is.I guess I should make sure it's still 
there before I request just the housing,LOL. 

  Dave Walters
  Denver, Co.

  64 Savoy Post
  64 Bel Post
  64 Dodge 330 Post
  63 Savoy


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@