New listings on the '62 to '65 Swap Meet

["Gary H." <62to65mopar@xxxxxxxxxxx>]

[AD removed for archives]
-------------------------------------------------------------------
Save up to 67% on Omaha Steaks + Get 6 FREE Burgers and a 
FREE Cutlery Set + Cutting Board!
caacBBEb7yoMza/OmahaSteaks
-------------------------------------------------------------------

Hi all,

Below are the latest listings on the '62 to '65 Swap Meet Page.

Enjoy!

Gary H.

~~~~

FOR SALE

Bill Miller Aluminum Rods.  For use with 572 mopar wedge set up.  Can 
make a 588" motor.  Like new only 10 runs.  $500.   Call Bill at 301 865 
2166 anytime and leave message.

INDY HEADS 572-13 for Mopar RB Stroker motor.  Castings only, ported and 
flowed to .410" on intake.  Set up for any valve spring.  Excellent 
condition.   $1,500 for both.  Call Bill at 301 865 2166 anytime and 
leave message.

Wedge Motor stroker crank.  4.500 Callies, Used very little - Standard 
size.  Perfect, condition, balanced and race ready. Cost $1,950 will 
SELL FOR $1,550. + SHIPPING.  Call Bill at 301 865 2166 anytime and 
leave message.

1964 Dodge Polara 2 dr hardtop 318 for sale. Needs restoration. Does run 
and drive. Has usual rust. Trunk is good. The motor is not original. It 
has an almost new 8-3/4 4.56 US Gear Sure Grip (clutch type). I was 
going to build a strip/street car but don't have time. I have an 8-3/4 
rear end housing out of a 1967 Coronet. I was going to get rid of the 
tapered axles. Asking $1500 obo. Houston area. I also have a '68 440 
.030 block and a '66 standard bore 440 block. I have the forged crank 
out of the '68. It is fresh .010/.010 with new in the box F/M bearings. 
$150 for each block and $150 for the crank. e-mail klockett@xxxxxxxxxxx 

[AD removed for archives]
-------------------------------------------------------------------
Should School Prayer be mandatory? Give us your opinion and win.
caacDvTb7yoMzf/PermissionData
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.