Re: [Chrysler300] C300 door handle removal

["obiwan10" <obiwan10@xxxx>]

I use a tool that I purchased thru the Eastwood Catalog. Does not look like Chrysler tool but does the job. Check out part number 52021 B at www.eastwoodcompany.com

Incidentally, where can I get those flat plastic washers referred to as "upholstery protecting washer"?

Roger Schaaf
----- Original Message ----- 
From: Bob Merritt Simplex Mfg 
To: Chrysler300@xxxxxxxxxxxxxxx 
Sent: Wednesday, February 05, 2003 11:59 AM
Subject: Re: [Chrysler300] C300 door handle removal


Interior window and door handle removal:

>From the service manual in the 'body and sheet metal' section, there is a
picture of the tool used to remove the handles.

http://www.chrysler300club.com/rcmstuff/handle/handle.html

Yes, there is a clip down in there which is hard to get at with screwdrivers
and blades. With the tool it is quick and easy. Without the tool, it is
possible to do, but so is obtaining saint hood.

But where to get the tool? Maybe someone else can answer that one.

Bob Merritt
NY freezing and snowing again......don't say it.....

----- Original Message -----
From: "Frank Bakanau" <FBAKANAU@xxxx>
To: <Chrysler300@xxxxxxxxxxxxxxx>
Sent: Wednesday, February 05, 2003 12:02 PM
Subject: [Chrysler300] C300 door handle removal


> I give up. How does one remove the interior door handles? There appears
to
> be a small U shaped clip, but I can not get it off. Do I need a special
> tool?
>
> Thanks,
> Frank in Eugene.



Yahoo! Groups Sponsor 
ADVERTISEMENT




To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 

To unsubscribe from this group, send an email to:
Chrysler300-unsubscribe@xxxxxxxxxxxxxxx



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 


[Non-text portions of this message have been removed]